Download 2019 Honda Accord Splash Guards Installation Instructions – Installing the Front Splash Guards 1. Turn the steering wheel fully counterclockwise. 2. Remove the two self-tapping screws from the left front inner fender and left front fender. 3. Using a pushpin, pierce the center of the clip on the left front fender. NOTE: Make sure to pierce the clip perpendicular. 4. Loosely install the left front splash guard to the left front inner fender and left front fender with one self-tapping screw supplied and two self-tapping screws removed in step 2.
5. While holding the left front splash guard against the left front inner fender and left front fender, tighten the three self-tapping screws as shown. NOTE: Make sure there are no gaps between the left front splash guard and the vehicle body. If there is a gap, loosen the self-tapping screws, hold the splash guard against the body, and tighten the screws. 6.Turn the steering wheel fully clockwise, and repeat steps 2 through 5 on the right side of the vehicle. Installing the Rear Splash Guards 7. Remove the two self-tapping screws and one clip from the rear bumper.