Download 2019 Honda Accord Trunk Spoiler Installation Instructions – 1. Open the trunk lid. Remove the trunk lid trim panel. 2. Close the trunk lid. To prevent the metal shavings from falling onto the trunk floor, attach masking tape to the trunk lid as shown. 3. Place the template on the left side of the trunk lid, and line up the template with the trunk lid as shown. Tape the template to the trunk lid with masking tape. 4. Using a felt-tip pen, mark the trunk lid through the template at the two holes on the template. 5. Remove the template.
6. Turn the template over, and repeat steps 3 through 5 on the right side of the vehicle. 7. Using a center punch, punch the centers of the four marks. NOTE: Set a center punch to the minimum power setting. 8. While wearing eye protection, drill the four center-punched marks on the trunk lid with a 3 mm drill bit. NOTE: Make sure to drill the marks perpendicular to the trunk lid. 9. While wearing eye protection, use an 8.5 mm Rotabroach bit to drill the two outer 3 mm holes as shown. NOTE: Drill perpendicular to the trunk lid.