Download 2019 Honda Civic Coupe 2 Door Cargo Net Installation Instructions – 1. Install the four bolts into the four anchors. 2. Open the trunk lid. Remove the four clips from the right trunk side lining. Repeat on the other side. 3. While wearing eye protection, drill the two clip holes in the right trunk side panel to 9 mm. Repeat on the other side. NOTE: To prevent drilling through the inner panel, wrap tape around the drill bit 10 mm (0.39 in.) away from the tip. 4. Pull away the weatherstrip, and pull back the right trunk side lining. 5. Remove any burrs, and apply touch-up paint to each hole.
6. Install two rivet nuts in the 9 mm holes you enlarged as described the following steps. 7. Screw the rivet nut onto the mandrel as shown. 8. Insert the rivet nut into the hole in the right trunk side panel, and install the hex wrench on the rivet nut tool. 9. While holding the rivet nut tool with the hex wrench, turn the open end wrench clockwise to install the rivet nut to the right trunk side panel. 10. Remove the rivet nut tool from the rivet nut by turning the hex wrench counterclockwise. 11. Repeat steps 4 through 10 on the other side. 12. Install both trunk side lining and weatherstrip.