Download 2019 Honda CR-V Heated Steering Wheel Installation Instructions – 1. Turn the steering wheel so the front wheels are in the straight-ahead position. 2. Disconnect the negative cable from the battery, and wait at least 3 minutes before you start to install the steering wheel. 3. Remove the driver’s dashboard under cover and unplug the vehicle connector (if equipped). 4. Remove the driver’s dashboard lower cover and unplug the vehicle connectors. 5. Remove the driver’s door sill trim. 6. Pull away the door opening seal, and remove the driver’s kick panel.
7. Lower and pull out the steering wheel as shown. 8. Insert a punch (diameter of 5.5 mm) through the left hole of the steering wheel cover, and push the spring to release the airbag. Repeat for the other side. 9. Unplug the cable reel cord 2-pin connector. Then, unplug the two cable reel 2-pin connectors using an SRS coupler puller as shown. NOTE: Be careful not to damage the connectors. 10. Remove the airbag. Do not drop the removed airbag or hit it on an object. Place the removed airbag in a safe place with the padded surface (top) facing up.