Home Auto Repair How to Install the Trailer Hitch on a 2019 Honda CR-V

How to Install the Trailer Hitch on a 2019 Honda CR-V

125

Download 2019 Honda CR-V Trailer Hitch Installation Instructions – 1. Disconnect the negative cable from the battery. 2. If equipped, remove the tonneau cover. 3. Fold down the left rear seat-back. 4. Remove the left rear door sill trim. 5. Remove the cargo floor board. 6. Remove the rear trim panel. 7. Remove the two tie-down hooks. 8. Remove the cargo floor lid from the floor carpet cover. 9. Remove the floor carpet cover. 10. Gently pull the inner handle on the left rear side trim panel, and use a small flat-tip screwdriver wrapped with a shop towel to remove the inner handle cap. 11. Remove the two screws from the left rear side trim panel.

12. Remove the hook and two clips. 13. Pull away the door opening seal and weatherstrip from around the left rear side trim panel. Remove the left rear side trim panel, and unplug the vehicle connector. 14. Release the cable from the left rear side trim panel, then remove the inner handle. 15. Remove the roof end trim panel. 16. Pull away the door opening seal and weatherstrip from around the left quarter pillar trim. 17. Using a rubber mallet wrapped with a shop towel, lightly tap the area marked “SIDE CURTAIN AIRBAG” on the left quarter pillar trim to push in the clip. Make sure to strike the area perpendicular to the vehicle.