Download 2019 Honda HR-V Cargo Net Installation Instructions – 1. Disconnect the negative cable from the battery. 2. Pull away the door opening seal. Remove the right rear door sill trim. 3. Repeat the same procedures for the other side. 4. Remove the tonneau cover, if equipped. 5. Pull the levers and fold each rear seat-back forward. 6. Using a plastic trim tool, pry open the screw cover. Remove the tie-down hook (one screw). Remove the other tie-down hook. 7. Remove the cargo floor lid. 8. Remove the tool box. 9. Pull away the weatherstrip in the area shown. Remove the rear trim panel.
10. Pull away the weatherstrip and the door opening seal. Remove the left rear side trim panel and unplug the vehicle connector, if equipped. 11. Pull away the weatherstrip and the door opening seal. Remove the right rear side trim panel. Installing the Anchor 12. Using a pushpin, pierce one scribe mark on the left rear side trim panel as shown. 13. While wearing eye protection, drill a 12 mm hole in the left rear side trim panel: • Wrap tape around each drill bit 10 mm (0.4 in.) away from the tip or use a drill stop.