Home Auto Repair How to Install Rear Lower Trim on 2019 Honda HR-V

How to Install Rear Lower Trim on 2019 Honda HR-V

92

Download 2019 Honda HR-V Rear Lower Trim Installation Instructions – 1. Remove the rear bumper. • Apply masking tape as shown. • Remove the four self-tapping screws on each side. • Remove the rear wheel arch protector on each side. • Remove the four hex bolts, four self-tapping screws, and four clips. • Release the 12 retaining tabs. • With the help of an assistant, remove the rear bumper. • Place the rear bumper on a blanket. 2. Mark the inside of the rear bumper: • Locate the 13 scribe marks on the inside of the rear bumper.

• Using a pushpin, pierce the rear bumper at the 13 scribe marks. NOTE: There are several scribe marks on the inside of the rear bumper. Before piercing the rear bumper, verify you have the correct locations. Make sure to pierce the scribe marks perpendicular to the rear bumper. 3. While wearing eye protection, drill these three pierced marks to 10 mm. First, drill with a 3 mm drill bit, then follow with a 6 mm drill bit and 8 mm drill bit, and finish with a 10 mm drill bit. Remove any burrs. NOTE: Make sure to drill perpendicular to the rear bumper.