Home Auto Repair How to Install Remote Engine Start System II on 2019 Honda HR-V

How to Install Remote Engine Start System II on 2019 Honda HR-V

98

Download 2019 Honda HR-V Remote Engine Start System II Installation Instructions – 1. Disconnect the negative cable from the battery. 2. Attach the ID label. • Using isopropyl alcohol on a shop towel, thoroughly clean the transmitter where the ID label will attach. • Attach the ID label to the transmitter as shown. 3. Remove the left and right lenses, and the two bolts. 4. Remove the map light console. Then, unplug the vehicle connectors, and remove the switch. 5. Release the passenger’s sunvisor from the passenger’s sunvisor holder.

6. Remove the passenger’s sunvisor holder. • Wrap masking tape around the tip of a flat-tip screwdriver. • Release the three retaining tabs on the passenger’s sunvisor holder. 7. Remove the driver’s sunvisor. • Pivot the driver’s sunvisor downward, and release it from the driver’s sunvisor holder. • Wrap masking tape around the tip of a flat-tip screwdriver. • Locate the slot in the base cover, and insert the flat-tip screwdriver into the slot. Push in, and hold the retaining tab.