Download 2019 Honda Fit LED Fog Lights Installation Instructions – 1. Disconnect the negative cable from the battery. 2. Remove the front bumper: • Apply masking tape as shown. • Remove the front grille cover. • Remove the air intake duct. • Remove the bolt, 6 self-tapping screws, and 10 clips. • With the help of an assistant, release the six retaining tabs on each side. NOTE: Remove the retaining tabs from the outside as shown. Make sure to remove the retaining tabs in the correct direction. • With the help of an assistant, remove the front bumper, and unplug the vehicle connectors.
Place the front bumper on a blanket to prevent damage. 3. Remove the left fog light from the left bracket. 4. Using a pushpin, pierce the left bracket as shown. 3. Remove the left fog light from the left bracket. 5. While wearing eye protection, drill the one pierced mark to 5 mm. • First, drill with a 3 mm drill bit, then finish with a 5 mm drill bit. 6. Using a file, remove any burrs from the hole. 7. Install the left LED fog light on the left bracket with two self-tapping screws.