Home Auto Repair How to Install the Splash Guards on a 2019 Honda Fit

How to Install the Splash Guards on a 2019 Honda Fit

112

Download 2019 Honda Fit Splash Guards Installation Instructions – Installing the Front Splash Guards 1. Turn the steering wheel fully counterclockwise. 2. Using a pushpin, pierce the centers of the three clips shown on the left front inner fender. 3. Secure the left front splash guard with three 5 x 25 mm self-tapping screws as shown. NOTE: Make sure there is no gap between the left front splash guard and the vehicle body. If there is a gap, loosen the self-tapping screws, hold the splash guard against the body, and tighten the screws.

4. Turn the steering wheel fully clockwise, and repeat steps 2 and 3 to install the right front splash guard on the right side of the vehicle. Installing the Left Rear Splash Guard 5. Remove the four clips and one self-tapping screw. 6. Remove the left rear fender cover and drain tube clip. 7. Locate the recessed mark. Using a pushpin, pierce the left rear fender cover at the recessed mark. 8. While wearing eye protection, drill the left rear fender cover at the pierced mark using a 3 mm drill bit first, then a 6 mm drill bit, an 8 mm drill bit, and finish using a 10 mm drill bit.