Download 2019 Honda Fit Sport Pedals Installation Instructions – Installing the Sport Pedals 1. Set the accelerator pedal cover as shown. 2. Using a white marker, mark the accelerator pedal as shown. 3. Remove the accelerator pedal cover. Using a pushpin, pierce the accelerator pedal as shown. 4. While wearing eye protection, drill the accelerator pedal at the three pierced marks using a 2 mm drill bit first, then finish using a 3.5 mm drill bit. NOTE: • Wrap masking tape around each drill bit 7 mm (0.28 in.) away from the tip, or use a drill stop.
• Hold the accelerator pedal firmly with your hand while drilling the hole. • Make sure to drill perpendicular to the accelerator pedal. Remove any burrs. 5. Using the hand riveter, secure the accelerator pedal cover to the accelerator pedal with three rivets A as shown. NOTE: • Make sure you use the correct rivet before proceeding with the installation. • Make sure the rivets are attached. If the vehicle is a CVT, continue with step 6. If the vehicle is a M/T, go to step 14. CVT models 6. Remove the brake pedal pad from the brake pedal.