Home Auto Repair 2019 Honda Insight Accessories Installation Instructions

2019 Honda Insight Accessories Installation Instructions

83

Download 2019 Honda Insight Accessories Installation Instructions – The following steps must be followed to ensure proper installation: • These kits should be installed only if the ambient air temperature is 15°C (60°F) or above. • To allow the adhesive to cure, do not wash the vehicle for 24 hours. Make sure your customer is aware of this. • Use the included template for proper alignment. • To ensure proper adhesion, thoroughly clean the vehicle’s surface with isopropyl alcohol. Then allow the surface to completely dry before installing the applicable accessory.

• Use a rubber roller to properly set the adhesive. • Be sure to use the 8.5 mm Rotabroach bit to make the holes needed to mount the spoiler. • Use a deburring tool to remove any burrs from the holes you made. This will ensure proper clip engagement. • To ensure proper adhesion, thoroughly clean the vehicle’s surface with isopropyl alcohol. Then allow the surface to completely dry before installing the applicable accessory. • To confirm clip engagement, listen for a ‘click’ during installation. • Don’t forget to install the stoppers included with the kit.