Home Auto Repair How to Install the Ambient Lights on a 2019 Honda Insight

How to Install the Ambient Lights on a 2019 Honda Insight

96

Download 2019 Honda Insight Ambient Lights Installation Instructions – 1. Remove the right side panel, and disconnect the negative cable from the battery. NOTE: Wait 3 minutes after turning the ignition to OFF before disconnecting the battery. 2. Pull away the door opening seal, and remove the passenger’s dashboard side lid. 3. Remove the passenger’s under cover. 4. Open the glove box, push inward on the glove box stops, and remove the glove box. 5. Remove the glove box cover. 6. Remove the driver’s dashboard lower cover, and unplug the vehicle connectors. 7. Apply masking tape as shown.

8. Remove the A/C control unit, and unplug the vehicle connector. 9. Remove the audio unit, and unplug the vehicle connectors. 10. Using a pushpin, pierce the driver’s dashboard lower cover as shown. NOTE: Pierce the scribe marks perpendicular on the driver’s dashboard lower cover. 11. While wearing eye protection, drill the pierced mark on the driver’s dashboard lower cover to 5 mm. First, drill with a 3 mm drill bit, then finish with a 5 mm drill bit. NOTE: Drill perpendicular to the driver’s dashboard lower cover.