Home Auto Repair How to Install Body Side Moldings on 2019 Honda Insight

How to Install Body Side Moldings on 2019 Honda Insight

114

Download 2019 Honda Insight Body Side Moldings Installation Instructions – 1. Fold the four tabs on the template as shown. 2. Line up the bottom of the template with the character line on the left doors, and center the hole of the template with the gap between the front and rear doors. Then, attach the template with masking tape as shown. 3. Using an alcohol wipe, thoroughly clean the left front door where the left front body side molding will attach. 4. Using an alcohol wipe, thoroughly clean the left rear door where the left rear body side molding will attach.

5. Peel back the adhesive backings, and tape them to the front surface of the left front body side molding with masking tape. Remove the other adhesive backings. 6. Line up the left front body side molding with the template, and install it on the left front door. 7. While applying light pressure against the left front body side molding, carefully remove the taped adhesive backings. 8. Using the rubber roller, apply firm pressure while rolling, especially at the ends, to set the adhesive.