Home Auto Repair How to Install Door Lining Illumination on 2019 Honda Insight

How to Install Door Lining Illumination on 2019 Honda Insight

106

Download 2019 Honda Insight Door Lining Illumination Installation Instructions – 1. Remove the right side panel, and disconnect the negative cable from the battery. NOTE: Wait 3 minutes after turning the power switch to OFF before disconnecting the battery. 2. Remove the left front door switch panel. 3. Remove the left front door lining. 4. Remove the left inside handle. 5. Repeat steps 2 through 4 on the right side of the vehicle. 6. Using isopropyl alcohol on a shop towel, thoroughly clean the fuse case where the fuse label will attach.

7. Attach the fuse label to the door lining illumination harness fuse case. 8. Plug the door lining illumination harness 2-pin connector into the vehicle 2-pin connector. Line up the edge of the fuse case on the door lining illumination harness with the branch of the vehicle harness, and secure it to the vehicle harness with one wire tie as shown. 9. Secure the door lining illumination harness to the vehicle harness with two wire ties as shown. 10. Using a pushpin, pierce the inside of the left inside handle through the center of two scribe marks.