Home Auto Repair How to Install Engine Block Heater on 2019 Honda Insight

How to Install Engine Block Heater on 2019 Honda Insight

115

Download 2019 Honda Insight Engine Block Heater Installation Instructions – 1. Remove the right side panel, and disconnect the negative cable from the battery. NOTE: Wait 3 minutes after turning the power switch to OFF before disconnecting the battery. 2. Allow the engine and all cooling system components to cool down. 3. Place the vehicle on a lift, and raise the vehicle off the ground. 4. Remove the front bumper. • Apply masking tape as shown. • Wrap a shop towel around the hood latch. • Remove the front bulkhead cover.

• Remove the millimeter wave radar cover. • Remove the two bolts and 12 clips. • Remove the four self-tapping screws, two hex bolts, and 11 clips. • With the help of an assistant, release the seven retaining tabs on each side. NOTE: Make sure you remove and release the retaining tabs as shown. • With the help of an assistant, remove the front bumper using a plastic trim tool, and unplug the vehicle connectors (if equipped). Place the front bumper on a blanket to prevent damage.