Home Auto Repair How to Install the Parking Sensors on a 2019 Honda Insight

How to Install the Parking Sensors on a 2019 Honda Insight

99

Download 2019 Honda Insight Parking Sensors Installation Instructions – 1. Remove the right side panel, and disconnect the negative cable from the battery. NOTE: Wait 3 minutes after turning the power switch to OFF before disconnecting the battery. 2. Pull away the door opening seal, and remove the passenger’s dashboard side lid. 3. Remove the passenger’s under cover. 4. Open the glove box, push inward on the glove box stops, and remove the glove box. 5. Remove the glove box cover.

6. Remove the driver’s dashboard lower cover, and unplug the vehicle connectors. 7. Pull away the door opening seal, and remove the driver’s dashboard side lid. 8. Remove the driver’s front door sill trim. 9. Pull away the door opening seal, and remove the driver’s kick panel. 10. Apply masking tape as shown. 11. Remove the A/C control unit, and unplug the vehicle connector. 12. Remove the audio unit, and unplug the vehicle connectors. 13. Remove the bolt from the rear seat cushion.