Home Auto Repair How to Install Rear Bumper Metal Panel on 2019 Honda Insight

How to Install Rear Bumper Metal Panel on 2019 Honda Insight

161

Download 2019 Honda Insight Rear Bumper Metal Panel Installation Instructions – Installing the Rear Bumper Metal Panel 1. Open the trunk lid. Attach masking tape to the rear bumper, and mark it using a felt-tip pen as shown. 2. Line up the sticker on the rear bumper metal panel with the mark on the masking tape. Then, attach masking tape at both ends as shown. 3. Remove the rear bumper metal panel. 4. Using an alcohol wipe, thoroughly clean the rear bumper where the rear bumper metal panel will attach.

5. Peel back the adhesive backings, and tape them to the front surface of the rear bumper metal panel with masking tape. Remove the remaining adhesive backings. 6. Attach the rear bumper metal panel to the rear bumper by lining it up with the masking tape as shown. 7. While applying light pressure to the rear bumper metal panel, carefully remove the taped adhesive backings as shown. 8. Using a rubber roller, apply firm pressure against the rear bumper metal panel and roll from the center to the outside. NOTE: Apply firm pressure, especially at the ends.