Home Auto Repair How to Install the Splash Guards on a 2019 Honda Insight

How to Install the Splash Guards on a 2019 Honda Insight

145

Download 2019 Honda Insight Splash Guards Installation Instructions – Installing the Front Splash Guards 1. Turn the steering wheel fully counterclockwise. 2. Remove the self-tapping screw and clip from the left front inner fender. 3. Using a pushpin, pierce the center of the clip on the left front inner fender. 4. Secure the left front splash guard with two self-tapping screws and one clip as shown. NOTE: Make sure there is no gap between the left front splash guard and the vehicle body. If there is one, loosen the self-tapping screws, hold the splash guard against the body, and retighten the screws.

Installing the Rear Splash Guards 5. Remove the two self-tapping screws and one clip from the rear bumper. 6. Locate the one dimple. Using a pushpin, pierce the rear bumper at the dimple. 7. Install one spring nut to the rear bumper as shown. NOTE: Make sure to install the spring nut in the correct position with the large hole facing out. 8. Secure the left rear splash guard with three self-tapping screws and one clip as shown. NOTE: Make sure there is no gap between the left rear splash guard and the bumper.