Home Auto Repair How to Install the Welcome Lights on a 2019 Honda Insight

How to Install the Welcome Lights on a 2019 Honda Insight

118

Download 2019 Honda Insight Welcome Lights Installation Instructions – 1. Remove the right side panel, and disconnect the negative cable from the battery. NOTE: Wait 3 minutes after turning the power switch to OFF before disconnecting the battery. 2. Pull away the door opening seal, and remove the passenger’s dashboard side lid. 3. Remove the passenger’s front door sill trim. 4. Pull away the door opening seal, and remove the passenger’s kick panel. 5. Remove the passenger’s under cover. 6. Open the glove box, push inward on the glove box stops, and remove the glove box.

7. Remove the glove box cover. 8. Remove the driver’s dashboard lower cover, and unplug the vehicle connectors. 9. Pull away the door opening seal, and remove the driver’s dashboard side lid. 10. Remove the driver’s front door sill trim. 11. Pull away the door opening seal, and remove the driver’s kick panel. 12. Turn the steering wheel fully counterclockwise. 13. Remove the two self-tapping screws shown above. 14. Remove the two self-tapping screws shown below.