Download 2019 Honda Odyssey Hood Air Deflector Installation Instructions – Installing the Hood Air Deflector 1. Open the hood. Fold back the rubber seal, and locate the four square holes on the inside of the hood. Push one grommet nut into each square hole in the hood. 2. Using an alcohol swab, thoroughly clean the hood where the protection film will attach. 3. Remove the adhesive backings from the four protection films, and attach them to the front of the hood area where the two brackets A and the two brackets B will mount.
4. Slide the two brackets A and the two brackets B over the lip of the hood, and line them up with the holes in the grommet nuts. Loosely install a short screw through each bracket. 5. Close the hood. Attach the template to the front edge of the hood on the driver’s side as shown. Secure the template to the hood with strips of masking tape. 6. Using an alcohol swab, thoroughly clean the hood where the left bracket C will attach. 7. Remove the adhesive backing from the left bracket C, line it up with the template, and press the left bracket C against the hood to set the adhesive.