Download 2019 Honda Odyssey Rear Bumper Trim Installation Instructions – 1. Disconnect the negative cable from the battery: • Wrap a shop towel around the hood latch. • Remove the front bulkhead cover. • Remove the intake air tube. • Disconnect the negative cable from the battery. 2. Remove the rear bumper: • Apply masking tape as shown. • Remove the six self-tapping screws, six clips, two large hex bolts, and two small hex bolts as shown. • With the help of an assistant, release the nine retaining tabs on each side.
• With the help of an assistant, remove the rear bumper and unplug the vehicle connectors (if equipped). • Place the rear bumper on a blanket. 3. Remove the step trim. 4. Remove the four adhesive backings from the rear bumper trim. 5. Using isopropyl alcohol on a shop towel, clean the rear bumper where the rear bumper trim will attach. 6. Starting from the center and working outward, install the rear bumper trim to the rear bumper with 15 caps and 15 self-tapping screws. NOTE: Ensure that all caps are rotated so that they are pointing towards the front of the vehicle as shown.