Home Auto Repair How to Install the Roof Rails on a 2019 Honda Pilot

How to Install the Roof Rails on a 2019 Honda Pilot

240

INSTALLATION
If the roof molding is equipped with a plastic cap, go to step 1; otherwise, go to step 3.
With plastic cap
1. Remove the plastic cap from the left roof molding as
shown.
2. Remove the nut from the stud bolt.
3. Remove the left roof molding as shown.
4. Open the tailgate. Using a plastic trim tool, release the left tailgate hinge cover extension as shown.
NOTE: Do not remove the tailgate hinge cover extension.
5. Close the tailgate halfway. Gently pry up on the rear edge of the left tailgate hinge cover, and remove it as shown. Do not reuse the left tailgate hinge cover.
6. Remove the two clips from the two stud bolts on the roof.
7. Install the left tailgate hinge cover onto the stud bolt.
8. Open the tailgate. Install the left tailgate hinge cover extension to the left tailgate hinge cover with one clip and one pin.
9. While wearing eye protection, use a reciprocating saw to cut the left roof molding at the measurement shown. Remove any burrs.