Download Removal Procedure 1. Center the steering wheel. 2. Turn the ignition OFF.3. Install the J42640 to the steering column.4. Important: Do NOT disconnect the battery cable from the engine. Disconnect the battery negative cable from the battery and the body. 5. Important: Do NOT disconnect the battery cable from the engine. Disconnect the battery positive cable from the battery and the underhood electrical center. 6. Position and secure the battery cables to the engine. 7. Remove the battery. 8. Remove the fuel injector sight shield. 9. Remove the air cleaner duct. 10. Disconnect the cooling fan electrical connectors (2 and 3). 11. Remove the cooling fan wiring harnesses (1 and 4) from the fan shroud. 12. Secure the wiring harnesses to the vehicle. 13. Drain the cooling system. 14. Important: Do NOT disconnect the surge hoses from the engine or the radiator. Disconnect the surge tank outlet hose from the surge tank. 15. Position and secure the surge hose to the engine. 16. Disconnect the surge tank inlet (vent) hose from the water outlet housing and the radiator. 17. Position and secure the surge tank inlet (vent) hose to the vehicle. 18. Disconnect the heater hoses from the heater core. 19. Disconnect the purge line (3) from the purge solenoid. 20. Disconnect the fuel pipe (2) from the fuel rail. 21. Plug the fuel pipe and cap the fuel rail to prevent fuel loss and/or contamination.