Home Auto Repair 2007 Acura TL 18 Aluminum Wheel Installation Instructions

2007 Acura TL 18 Aluminum Wheel Installation Instructions

106

Download Installation : 1. Install the valve stem and the screw to the tire pressure sensor. 2. Before installing the tire pressure sensor, clean the mating surface and the valve hole of the aluminum wheel. 3. Install the tire pressure sensor to the aluminum wheel and loosely install the valve nut. Make sure the pressure sensor is resting on the wheel. 4. Tighten the valve nut to the specified torque while holding the tire pressure sensor toward the wheel. You may hear a snap or pop as you tighten the nut. This is normal. Tightening torque: 4 N·m (3 lb-ft) 5. Install the tires according to the instructions in the Service Manual. 6. Using isopropyl alcohol on a shop towel, clean the area where the center cap emblem will attach. 7. Remove the adhesive backing from the center cap emblem. 8. Attach the center cap emblem to the wheel center cap by aligning its pins with the holes in the wheel center cap. After attaching, hold the emblem firmly against the wheel center cap with the palm of your hand for 30 seconds. 9. Slide the push nuts onto the pins. Note the direction of the push nuts. 10. Open the driver’s side door. Using isopropyl alcohol, clean the area where the accessary tire pressure caution label will attach. Remove the adhesive backing from the label and attach it over the existing tire information label. Attach the tire pressure caution label A or B according to the following information: 11. Memorize the ID tire pressure sensor as described on the next page. 12. Connect the HDS to the vehicle, make sure the correct VIN is populated and enter the mileage.