Home Auto Repair 2012 Acura TL Remote Control Engine Starter Installation

2012 Acura TL Remote Control Engine Starter Installation

73

Download Installation : NOTE: The antenna should be installed only if the ambient air temperature is 15°C (60°F) or above. 1. Make sure you have the anti-theft codes for the audio and navigation system (if equipped), then write down the audio presets. 2. Check the settings of the switches on the control unit. NOTE: If the switch settings are not correct, the remote control engine starter will not operate correctly. 3. Using a small flat-tip screw driver, set the switches on the control unit. 4. Check the settings of the switches on the control unit. NOTE: If the switch settings are not correct, the remote control engine starter will not operate correctly. 5. Using a small flat-tip screw driver, set the switches on the control unit. 6. Using isopropyl alcohol on a shop towel, clean the control unit where the protective tape will attach. Remove the adhesive backing, and attach the protective tape to the control unit over the switch opening. 7. Lower the tilt lever and pull the steering wheel out. Remove the two lower self-tapping screws and the lower screw. 8. Turn the steering wheel as necessary to access each self-tapping screw, and remove the two self-tapping screws. 9. Remove the upper steering column cover and the lower steering column cover:• Starting with the left side, use a small flat-tip screwdriver to push in to release the tab, then push in on the side of the upper steering column cover in the area shown to release the rear tab. Shift the column covers to the right, and repeat the same procedure.• Release the four hooks, and remove the upper steering column cover and the lower steering column cover.