Home Auto Repair 1999-2000 GMC Yukon Pro.Fit VSM Installation Instructions

1999-2000 GMC Yukon Pro.Fit VSM Installation Instructions

84

Download PLEASE READ COMPLETE INSTRUCTIONS BEFORE INSTALLING THIS Pro.Fit VSM. All instructions assume a drivers seat vantage point. Caution is advised when removing and reassembling wood or plastic parts of a dash. Applying unnecessary force or pressure may cause a piece to crack or break. Pro.Fit logo and part number will be right side up and readable when installed. STEP 1. Begin by removing four (4) 9/32” bolts along the bottom of the panel under the steering column. Release the six (6) retainer clips on panel. There are three (3) clips on right and three (3) on left of the steering column. Work your hand under the panel and gently pull loose. Panel does not need to be completely removed. Let the panel hang. STEP 2. Note – Step 2 must be followed exactly. Loosen the two (2) 9/32” bolts that hold the cup holder in place. Place Pro.Fit VSMTM into position placing slots on right side of mount behind the factory screws. IMPORTANT!!! DO NOT TIGHTEN BOLTS AT THIS TIME!!! Apply upward pressure to mount, holding it up against dash. Locate hole in Pro.Fit VSMTM that is to the left of the “U” shaped cutout. Using 5/64” drill bit and drill, drill starter hole. Insert and secure one (1) #8×3/4” screw. Using 5/64” drill bit and drill, drill starter hole, in hole that is above and to the left of the “U” shaped cutout in Pro.Fit VSMTM. Insert #10×3/4” screw and secure. Tighten factory bolts resecuring cup holder. STEP 3. Re-install trim panel. Reinstall four (4) factory screws. Install hang up cup onto Pro.Fit VSM.