Home Auto Repair Audi TT RS Front Mounted Intercooler Installation Instructions

Audi TT RS Front Mounted Intercooler Installation Instructions

64

Download 1. Park vehicle securely, jack the front of the car and support on axle stands so that the front wheels are clear of the ground ,raise the bonnet. Now remove the two plastic trims which cover the lights by pulling the trim in the direction indicated by arrow “A” from under the slam panel. Then pull off cover in the direction of the arrow “B” to completly remove the trim. 2. Now the covers have been removed you will be able to see the back of the light. Unplug the connecter from behind the headlight on the passenger side, by pushing down where indicated and pulling the plug backwards in the direction of wiring. Repeat for the drivers side headlight. 3. Undo the three T30 screws retaining the headlights,these can be seen by looking directly down on the headlights ,The one to the left and the one to the right only need to be loosend where as the one in the middle will need to be taken out. 4. Now the lights have been removed you will be able to see where the wing and bumper are bolted together. Remove the two 10mm nuts which hold the bumper to the wing, and repeat this on the drivers side. 5. Remove the two lower T25 screws conecting the bumper to the arch liner. You will need to turn the wheels on full lock to gain access. Repeat on both sides. This is the view from under the car looking up at the bumper and under tray. Now remove the four T25 screws that connect the bumper to the undertray