Download Audi R8 Carbon Fiber Ashtray Lid Installation Instructions Tools Required 1 MAcarbon Interior Install Tools Installation Steps Step Instructions 1. Open the ashtray lid and pull out the ashtray cup. 2. With the cup out, the two gray tabs that hold down the ashtray assembly should be exposed. 3. Use an interior install tool to push the tabs inwards. 4. Pull the ashtray assembly out by one corner and then the other. 5. Disconnect the cigarette lighter lead from the underside of the ashtray assembly. 6. The ashtray lid is held on by two press clips on the right side. Use the install tool to bend out the lid and undo the two snaps. 7. Place the ashtray into the carbon lid. The carbon lid is stiffer than the original lid. It may be more difficult to get fully attached. The unit can be put onto a table top and pressed in from above. Be sure to place a towel on the surface to prevent any scratching. 8 Follow the reverse steps to put everything back together and you are all done! You now have a gorgeous carbon fiber ashtray lid!