Home Auto Repair Custom Billet Aluminum Locking Fuel Door For The Hummer H2

Custom Billet Aluminum Locking Fuel Door For The Hummer H2

78

Download Custom Billet Aluminum Locking Fuel Door For The Hummer H2 – STEP 1. Removing Plastic Factory Fuel Insert Bezel Using a 7mm socket remove the 3 screws that hold the plastic fuel insert bezel in place around the fuel fill flange. (See Step 1A.) Next push against the bezel area and turn counter clockwise to remove the plastic insert piece from the 3 slots in the body of the H2. (See Step1B and 1C.) STEP 2. Installing the billet fuel door onto the plastic factory insert bezel. Begin by removing the plastic fuel cap cord from the insert bezel. (See Step 2A.) Then line up the opening where you removed the plastic fuel cap cord with the notch mark on the billet fuel door surround. (See Step 2B.) Then at the same time slid the plastic insert bezel under the two projection areas around the edge of the billet surround piece. (See Step 2C.) Continue pushing until the plastic insert bezel is completely pushed into the billet surround piece. See 2c. Note: Make sure the plastic insert bezel is still lined up with the mark on the billet surround piece. If not you can rotate the plastic insert bezel a little so that it lines up. Next install the two phillips head screws. (See Step 2D.)