Home Auto Repair How to Install Ambient Lights on 2012 Honda Crosstour

How to Install Ambient Lights on 2012 Honda Crosstour

73

Download How to Install Ambient Lights on 2012 Honda Crosstour – 1. Make sure you have the anti-theft codes for the audio and navigation system (if equipped), then write down the radio station presets. 2. Disconnect the negative cable from the battery. 3. Remove the passenger’s dashboard under cover (three clips and two pins). 4. Remove the driver’s dashboard lower cover (eight clips, two hooks, and vehicle stability assist connector). 5. Remove the driver’s dashboard under cover (three clips and one pin). 6. Gently pull out the center console, and remove the one clip. Remove the driver’s center lower cover (one clip and two hooks). Installing the Ambient Light Switch 7. Remove the pocket (three self-tapping screws). 8. Remove the VSA switch (two retaining tabs). 9. Install the VSA switch (removed in step 8), and the ambient light switch into the switch trim. 10. Install the switch trim to the driver’s dashboard lower cover using the three self-tapping screws removed in step 7. 11. Using isopropyl alcohol on a shop towel, clean the area where the fuse label will attach. Attach the 2A fuse label to the fuse case on the ambient light harness.