Home Auto Repair Lamborghini Gallardo Center Shift Hump Installation Manual

Lamborghini Gallardo Center Shift Hump Installation Manual

67

Download Lamborghini Gallardo Center Shift Hump Installation Manual – Stock Air Vent Removal Steps 1 Using the low tack tape, tape off the leather around the shift hump. 2 Using the MAcarbon chisel pry tool, pry up the center console from the rear. The plastic pry tool prevents any damage occurring to the plastic. 3 Lift up the hump once the rear has been removed. 4 Flip the console over. Remove the electrical plug from the E-Gear control. 5 Remove the plug from the external mirror switch. 6 Remove the plug from the suspension lifting control. 7 Take the stock hump to the workbench. Push out the mirror control from the rear of the panel. 8 Using the 10MM socket, remove the nuts from the control panel. 9 Lay out the E-Gear panel and take this opportunity to clean all the parts. 10 Push the mirror control into the carbon piece. 11 Move the E-gear puck over to the carbon panel. Insert the screws. 12 Turning the console over, place the spacer tubes onto the screws. 13 Put on the E-Gear control panel. Hand tighten the nuts onto the base. Once adjusted, tighten them with the 10MM socket. 14 For the truly ‘anal’, be sure to line up the screws on the top of the E-Gear puck. These can be adjusted using a 5MM Allen screw. 15 You are now ready to place the carbon hump into the car. 16 Take the opportunity to clean all the dust from the various bits around the shift hump.