Home Auto Repair Outlander Inner Carrier Base Bar Installation Procedures

Outlander Inner Carrier Base Bar Installation Procedures

77

Download Outlander Inner Carrier Base Bar Installation Procedures – A. PREPARATORY WORK 1) Insert the bolt into the hole of the fixture . Then pass the nylon washer through the bolt as deep as possible to hold the bolt in position. Two units should be prepared for one pipe. 2) Insert the bolt into the slot on the pipe . (Set the fixture with bolt to each end of the pipes B. INSTALLING THE BASE BARS ON THE UTILITY BARS 1) Set the bar with fixtures to the utility bars in the luggage compartment from the underside of the utility bars. 2) Set the fixtures over the bar by passing the bolt through the square hole on the fixture . Then screw in the adjust knobs to the bolts . 3) Place the base bar to the desired position and fix it securely by tightening the two adjust knobs . C. CHECKING AFTER INSTALLATION • Check that the base bars are correctly and securely mounted to the utility bars. • Shake the base bars to check if the base bars are rigid. • If any abnormality is found, reinstall the base bars in accordance with the installation procedures.