Home Auto Repair 2004 Mazda 6 V6-3.0l Dohc Timing Chain Removal And Installation

2004 Mazda 6 V6-3.0l Dohc Timing Chain Removal And Installation

37

Download Remove the front drive belt. Remove the P/S oil pump and bracket with the P/S pipe connected, and fix the P/S oil pump using a rope to prevent it from falling. Remove the A/C compressor with the A/C pipe connected, and fix the A/C compressor using a rope to prevent it from falling. Disconnect the generator, but do not remove it from the vehicle. After disconnection, fix the generator using a rope to prevent it from falling. Remove the drive shaft (RH). Remove the front crossmember. Remove the TWC (LH). Remove the, oil pan. Remove in the order indicated in the table. Install in the reverse order of removal. Start the engine and: Inspect for the engine oil, engine coolant, transaxle oil and fuel leakage. Verify the ignition timing, idle speed and idle mixture. 15. Perform a road test. Water Pump Drive Belt Pulley Removal Note 1. Replace part A of the SST [303-009 (49 UN30 3009)] with the SST [303-457 (49 UN30 3457)]. 2. Remove the water pump pulley using the SSTs. Camshaft Oil Seal Removal Note 1. Cut the oil seal lip using a razor knife. 2. Remove the oil seal using ascrewdriver as shown. Cylinder Head Cover (LH) Removal Note 1. Remove the cylinder head cover bolts in the order shown. Engine Hanger Removal Note 1. Lift up the vehicle and loosen the engine hanger installation bolts from under the vehicle.