Home Auto Repair 2015 Acura RLX Rear Bumper Applique Installation Guide

2015 Acura RLX Rear Bumper Applique Installation Guide

94

Download 2015 Acura RLX Rear Bumper Applique Installation Guide – 1. Open the trunk lid. Using the alcohol swab, thoroughly clean the area where the applique will attach. 2. Using a spray bottle with 3M protective tape application solution, spray the area where the applique will attach. 3. Remove the adhesive backing (side with the 3M mark) from the applique. 4. Spray the applique with 3M protective tape application solution. 5. Using a felt-tip pen, make a mark on the rear bumper at the center of the trunk lid anchor. 6. Align the v-notch on the applique with the mark on the rear bumper. Align the edge of the protective film on the applique with the bottom of the character line. Do not touch the adhesive side of the applique with your hands. 7. Insert the applicator into the soft sleeve. 8. Starting from the center and working outward, use the soft sleeve to smooth out the center of the upper section on the protective film. Move the soft sleeve in one direction only. If you see an air bubble, stop and gently peel up that section to work out the bubble. 9. Starting from the center and working outward, use the soft sleeve to smooth the applique on the left and right side of the upper section on the applique. Move the soft sleeve in one direction only. If you see an air bubble, stop and gently peel up that section to work out the bubble. Work slowly and keep pressure against the applique.