Home Auto Repair 2015 Accord Remote Control Engine Starter Installation

2015 Accord Remote Control Engine Starter Installation

81

Download 2015 Honda Accord 2 and 4-Door Remote Control Engine Starter Installation Instructions – 1. Disconnect the negative cable from the battery. 2. Attach the ID label. • Using isopropyl alcohol on a shop towel, clean the area where the ID label will attach. • Attach the ID label to the transmitter in the area as shown. With Keyless Memory Settings NOTE: The remote is factory set for driver 1 remote control. To program the driver 2 remote, follow the “REMOTE CONTROL ENGINE STARTER TRANSMITTER REGISTRATION” instructions on ISIS. 3. If equipped, remove the roof console. • Using a plastic trim tool, pry out and remove the left and right lenses (four retaining tabs each). • Open the sunglass holder. Remove four screws. • Remove the roof console (unplug the vehicle connectors). 4. Remove two sunvisor holders by rotating them 90° counterclockwise. 5. Wrap the end of a flat-tip screwdriver with tape. Locate the slot in the bracket cover, and insert the flat-tip screwdriver into the slot. Push the hook with the screwdriver. 6. While pushing in on the hook, rotate the driver’s sunvisor backward about 45°. Make sure the hook slides into the bracket cover. NOTE: If the hook did not stay pushed in, return the driver’s sunvisor to its original position and repeat steps 5 and 6. 7. Remove the driver’s sunvisor (unplug the vehicle connector).