Home Auto Repair 2015 Honda Accord 2-Door 19″ Aluminum Wheel Installation

2015 Honda Accord 2-Door 19″ Aluminum Wheel Installation

81

Download 2015 Honda Accord 2-Door 19″ Aluminum Wheel Installation Instructions – 1. Open the driver’s door. Using isopropyl alcohol on a shop towel, thoroughly clean the area where the tire pressure information label will attach. Remove the adhesive backing from the label, and attach it over the standard tire pressure information label as shown. 2. Attach the “Supplemental Information” page included in this kit into the Owner’s Manual. For the method of attaching the page, refer to “Important Information to Dealer” attached to the “Supplemental Information” page. TMPS Cailbration Before You Start 1. Make sure the vehicle is completely stopped with the trans in Neutral (M/T) or Park (A/T or CVT) 2. Set the tire pressures to the cold inflation values listed on the driver’s doorjamb label. 3. Turn on the ignition. Starting Calibration Models Without MID Press and hold the TPMS button underneath the left side of the dashboard for 3 seconds until the low tire pressure/TPMS indicator blinks twice. Models With MID 1. Press the up or down arrow button on the steering wheel to select the Vehicle Settings, then press the SEL/RESET button. TPMS Calibration comes up 2. Pres the SEL/RESET button. Display switches to Setup, where you can select Cancel or Calibrate. 3. Press the arrow buttons to select Calibrate, then press the SEL/RESET button. You’ll then see Calibration Started.