Home Auto Repair 2015 Accord 2-Door Cargo Net Installation Instructions

2015 Accord 2-Door Cargo Net Installation Instructions

84

Download 2015 Honda Accord 2-Door Cargo Net Installation Instructions – 1. Open the trunk. Pull the lever, and fold the rear seat back forward. 2. Remove the trunk floor (two clips). 3. Remove the trunk rear trim panel (four clips and five hooks). 4. Push on the tabs, and remove the cargo hook. 5. Pull away the weatherstrip. Remove the left trunk side trim panel (five clips). 6. Remove the right trunk side trim panel the same way. Installing the Anchors 7. While wearing eye protection, use a 9 mm drill bit to enlarge the four clip holes (two on each side): • Wrap electrical tape around a 9 mm drill bit 10 mm (0.4 in.) away from the tip, or use a drill stop. • Using the 9 mm drill bit, enlarge the four clip holes. • Remove all burrs and apply touch up paint to each hole. 8. Thread the rivet nut onto the mandrel of the rivet nut tool as shown. 9. Insert the rivet nut into the hole in the trunk left side panel and install the hex wrench on the rivet nut tool. 10. While holding the rivet nut tool with the hex wrench, turn the 19 mm wrench counterclockwise and install the rivet nut into the drilled hole in the vehicle panel. 11. Remove the tool from the rivet nut by turning the hex wrench counterclockwise. 12. Repeat steps 8 through 11 to install a second rivet nut on the left side, and the two rivet nuts on the right side. 13. Reinstall the left trunk side trim panel as shown.