Home Auto Repair 2015 Acura TLX 19″ Aluminum Wheel Installation Manual

2015 Acura TLX 19″ Aluminum Wheel Installation Manual

87

Download 2015 Acura TLX 19″ Aluminum Wheel Installation Instructions – 1. Before installing the tire pressure sensor, clean the mating surface on the sensor and the aluminum wheel. 2. Install the tire pressure sensor and the washer on the aluminum wheel, and tighten the valve nut finger tight. Make sure the pressure sensor is resting on the wheel. 3. While holding the tire pressure sensor against the wheel, torque the valve nut to 8.0 N·m (0.8 kgf·m, 5.9 lbf·ft) 4. Install the tires according to the Service Manual. 5. Install the wheels on the vehicle and torque to 108 N·m (11 kgf·m, 80 lbf·ft). 6. Drive the vehicle for at least 40 seconds at a speed of 24 km/h (15 mph) or more. All sensor IDs will be memorized automatically. TIRE AND LOAD INFORMATION LABEL Install the new label in the driver’s doorjamb: 1. Open the driver’s door. Using isopropyl alcohol on a shop towel, clean the standard tire label. 2. Check the spare tire specification, and choose the new label (A or B) that matches the specification. 3. Attach the new label over the standard label as shown. NOTE: • Check the grommet on the tire pressure sensor to make sure it is seated properly. • Make sure the valve stem does not protrude into the sensor housing surface. • To prevent the sensor housing from getting caught on the bead of the tire, install the tire pressure sensor so that the sensor housing does not protrude into the bead area of the wheel.