Download 2015 Honda Accord 2-Door HFP Floor Carpet Mats Installation Instructions – 1. If equipped, remove the standard floor carpet mats. 2. Install the rings in the driver’s floor carpet mat over the anchors. Push the rings into the anchors to secure the retaining tabs, then turn the knob on each anchor 90° to secure the driver’s floor carpet mat. 3. Place the passenger’s floor carpet mat in the passenger’s footwell. 4. Place the left and right rear floor carpet mats in front of the rear seats as shown. 5. Install the ring in the right rear floor carpet mat over the anchor. Push the ring into the anchor to secure the retaining tabs, then turn the knob on the anchor 90° to secure the right rear floor carpet mat. NOTE: • An anchored mat is required for the driver’s side of the vehicle; the anchor prevents the mat from sliding forward and possibly interfering with the pedals. • If you remove the floor carpet mat, make sure you reanchor it when you put it back in your vehicle. • If you replace the floor carpet mats, use factory all-season floor mats that are designed to be used with the anchor. • If you use a non-factory mat in the driver’s foot well, make sure it fits properly and that it can be used with the anchor. • Do not put an additional mat on top of the anchored mat. It may slide forward and possibly interfere with the pedals.