Home Auto Repair 2015 Civic 2 and 4-Door 17″ Aluminum Wheel Installation

2015 Civic 2 and 4-Door 17″ Aluminum Wheel Installation

79

Download 2015 Honda Civic 2 and 4-Door 17″ Aluminum Wheel Installation Instructions – 1. Open the driver’s door. Using isopropyl alcohol on a shop towel, thoroughly clean the area where the tire pressure information label will attach. Remove the adhesive backing from the label, and attach it over the standard tire pressure information label as shown. 4-door vehicle:… 2-door vehicle:…. 2. Attach the “Supplemental Information” page included in this kit into the Owner’s Manual. For the method of attaching the page, refer to “Important Information to Dealer” attached to the “Supplemental Information” page. Inch-up Tire Pressure Programming 3. Connect the HDS/MVCI to the data link connector, then turn the ignition switch on. 4. Start the Honda Diagnostic System. 5. Select the “Honda Systems” and click the check button. 6. Select the “ABS TCS VSA” and click the check button. 7. Select the “TPMS (VSA) threshold” and click the check button. 8. Select the “YES.” 9. Select the “17 inch” and “Mud and snow”, and click the check button. 10. Select the “YES.” 11. Click the check button. 12. Turn the ignition switch off. 13. The following message will display: “Turn the ignition switch to ON.” Then turn the ignition switch on. 14. Disconnect the HDS. 15. Perform the TPMS calibration according to the instructions in the Service Manual (TPMS Calibration).