Download 2015 Honda Civic 2/4-Door Ambient Lights Installation Instructions – 1. Disconnect the negative cable from the battery. 2. Remove the glove box: • Remove two bolts. • Open the glove box, push inward on the stops, and remove the glove box. 3. Remove the driver’s dashboard lower cover (nine clips and unplug the vehicle connectors, if equipped). 4. To protect the vehicle, attach tape to the dashboard in the areas shown. Move the shift lever to the N (neutral) position, and wrap a shop towel around the shift lever. 5. Remove the center lower panel (two self-tapping screws, four clips, and unplug the vehicle connectors, if equipped). Routing the Ambient Light Harness 6. Get the ambient light harness. Using isopropyl alcohol on a shop towel, clean the fuse case where the fuse label will attach. 7. Attach the fuse label (2A AMBIENT LIGHT) to the ambient light harness fuse case. 8. Under the driver’s dashboard, align the green tape on the ambient light harness with the hole in the dashboard panel. Secure the ambient light harness to the dashboard panel with one wire tie at the green tape. If another accessory harness is already attached to the dashboard panel, route and attach the ambient light harness below the other harness. 9. Secure the ambient light harness with one additional wire tie in the other hole in the dashboard panel.