Home Auto Repair 2015 Acura RDX Fog Lights Installation Instructions

2015 Acura RDX Fog Lights Installation Instructions

103

Download 2015 Acura RDX Fog Lights Installation Instructions – Illustration of the Fog Lights on the Vehicle 1. Lower the tilt lever, and release the column band (two clips). 2. Press the ENGINE START/STOP button to change the power mode to “ON.” Turn the steering wheel 90° clockwise. Using a plastic trim tool, release the lock as shown. 3. Turn the steering wheel 180° counterclockwise. Using a plastic trim tool, release the lock as shown. 4. Remove the upper column cover (two retaining tabs and two hooks). 5. Remove one self-tapping screw from the lower column cover. 6. Turn the steering wheel 180° clockwise. 7. Remove one self-tapping screw from the lower column cover. 8. Remove the lower column cover (one self-tapping screw). 9. Press the ENGINE START/STOP button to change the power mode to “OFF.” 10. Disconnect the negative cable from the battery. 11. Unplug the vehicle connector from the light switch. 12. Push in the two retaining tabs, and remove the light switch from the steering column. NOTE: Do not pull on the lever. 13. Install the new light switch to the steering column. Make sure both retaining tabs are fully engaged. NOTE: Do not push on the lever. 14. Plug the vehicle connector to the new light switch. Make sure the vehicle harness is not stretched. 15. Attach masking tape to the front bumper, left headlight and left front fender as shown.