Home Auto Repair 2015 Civic 2-Door Full Nose Mask Installation Instructions

2015 Civic 2-Door Full Nose Mask Installation Instructions

91

Download 2015 Honda Civic 2-Door Full Nose Mask Installation Instructions – Installing the Hood Section 1. Open the hood. Fit the corners of the mask around the hood. Adjust the mask so that it fits smoothly over the edges. Attach four S-hooks to the hood by inserting your finger into the belt of each hook. Installing the Bumper Section 2. Turn the steering wheel all the way clockwise. 3. Pry out the plastic pin, and remove the expansion clip that fastens the left front inner fender. Remove and retain the clip, then clean the area around the hole. 4. Press one fenderwell nut (supplied) into the hole in the left fender flange. 5. Place a washer onto the snap-screw, and install one snap-screw into the fenderwell nut. Securely tighten the snap-screw. 6. Turn the steering wheel all the way counterclockwise, and repeat steps 3 through 5 on the right side of the vehicle. 7. Slip the pocket of the mask bumper section onto the front corner of the left front fender. 8. Attach the S-hook to the mask on the left front fender. 9. Pull the mask back toward the fenderwell, smooth out any wrinkles, and secure the snap on the mask to the snap-screw. 10. Attach two hooks to the fenderwell, and one hook to the bottom edge of the bumper. 11. Pull the mask across the front bumper, smooth out any wrinkles, and attach the mask to the right side of the vehicle the same way.