Home Auto Repair 2015 Acura RDX Rear Bumper Applique Installation Manual

2015 Acura RDX Rear Bumper Applique Installation Manual

94

Download 2015 Acura RDX Rear Bumper Applique Installation Instructions – 1. Attach masking tape to the rear bumper. Use a felt-tip pen to mark the masking tape as shown. 2. Align the rear bumper applique to the rear bumper and check the rear bumper applique installation position. 3. Remove the rear bumper applique. 4. Use the alcohol swab to thoroughly clean the area where the rear bumper applique will attach. 5. Using a spray bottle with the 3M protective tape application solution, spray the area where the rear bumper applique will attach. Spray some solution on your hands. 6. Remove the adhesive backing from the side of the rear bumper applique with the 3M mark. 7. Spray the rear bumper applique with the 3M protective tape application solution. 8. Align the v-notch on the rear bumper applique to the mark on the masking tape, and align the edge along the crease of the curved surface as shown. Smooth the rear bumper applique along the rear bumper. 9. Insert the applicator into the soft sleeve. 10. Starting from the center and working out ward, usethe soft sleeve to smooth out the center of the rear bumper applique upper section. Move the soft sleeve in one direction only. If you see an air bubble, stop and gently peel up that section to work out the bubble. Work slowly and keep pressure against the rear bumper applique.