Home Auto Repair 2015 Acura MDX Front Lower Trim Installation Instructions

2015 Acura MDX Front Lower Trim Installation Instructions

108

Download 2015 Acura MDX Front Lower Trim Installation Instructions – 1. Disconnect the negative cable: • Wrap a shop towel around the hood latch. • Remove the front bulkhead cover (10 clips). • Remove the intake air tube (two clips). • Disconnect the negative cable from the battery. 2. Remove the front bumper: • Attach tape to the areas shown on each side. • Remove the intake air guide (three clips). • Remove six self-tapping screws, four long clips, four washer-bolts, and four flange bolts. • Release five retaining tabs on each side. • With the help of an assistant, release five retaining tabs on each side. • With the help of an assistant, release the front bumper (five short clips, two long clips, and unplug the vehicle connectors). • If the vehicle is equipped with headlight washer, place a suitable container under the tube end to collect the washer fluid from the washer tube. Refill the washer tank up to the proper level after installing the front bumper. Disconnect the headlight washer tube. • Remove the front bumper. Place the front bumper on the blanket to prevent damage. With parking and backup sensor system 3. Release the vehicle harness clip from the front bumper on each side. 4. Using a piece of tape, temporarily attach the vehicle harness out of the way as shown. 5. Using a pushpin, pierce the seven dimples in the front bumper.