Home Auto Repair 2015 Honda Crosstour Door Edge Film Installation Manual

2015 Honda Crosstour Door Edge Film Installation Manual

97

Download 2015 Honda Crosstour Door Edge Film Installation Instructions – Installing the Front Door Edge Film 1. Open the driver’s door. Using an alcohol wipe, thoroughly clean the area where the left front door edge film will attach. 2. Close the driver’s door. Using a spray bottle with 3M protective tape application solution, spray the area where the left front door edge film will attach. NOTE: Do not spray the inside edge of the door. 3. Open the driver’s door again. Peel back about 50 mm (2 in.) of adhesive backing from the left front door edge film. Align the V-notch in the door edge film with the end of the character line on the upper part of the door. 4. Continue to remove the adhesive backing while you align the center line of the door edge film with the edge of the door. 5. Insert the applicator into the soft sleeve. Starting from the top and working downward, use the applicator with the soft sleeve to smooth out any bubbles in the film. To avoid lifting the film, move the applicator in only one direction. 6. When you are satisfied that the door film is firmly attached to the edge of the door, slowly remove the outer protective film. 7. Starting from the middle of the door edge film and working outward, fold the left front door edge film around the edge of the driver’s door using your fingers. Move your fingers in one direction. Attach the film over the seam sealant. Do not trim or damage the seam sealant.