Download 2015 Honda Crosstour Remote Control Engine Starter Troubleshooting – Remote Control Engine Starter Operation 1. Press the start button of the transmitter to send the start signal. 2. When the control unit receives the start signal, it checks the start conditions listed below… 3. When the start conditions listed above have been met, the control unit switches on the IG1 relay and checks the start conditions listed below…. 4. When the start conditions listed above have been met, the control unit switches on the starter signal to start the engine. 5. When the charge indicator goes off, the control unit interprets this to mean that the “engine has started”, and it switches off the starter signal. 6. When the engine starts successfully, the control unit turns on the IG2 relay and transfers to the warm-up operation. 7. When one of the conditions listed below is input during the warm-up operation, the control unit switches off the IG1 relay and IG2 relay to stop the engine… Self-diagnostic Function Checking the Engine (Doesn’t) Run History If the engine has failed to start, the engine (doesn’t) run history of the engine can be displayed by the transmitter. By taking the following steps, the last 8 events in the engine (doesn’t) run history are displayed in sequence starting with the latest event. * For details of the displays, refer to the symptom-to-cause chart (see page 8).