Home Auto Repair 2015 Honda Fit Remote Control Engine Starter Installation

2015 Honda Fit Remote Control Engine Starter Installation

101

Download 2015 Honda Fit Remote Control Engine Starter Installation Instructions – 1. Disconnect the negative cable from the battery. 2. Attach the ID label. • Using isopropyl alcohol on a shop towel, clean the transmitter where the ID label will attach. • Attach the ID label to the transmitter in the area as shown. 3. Remove the driver’s sunvisor: • Pivot the driver’s sunvisor downward. • Wrap tape around the tip of flat-tip screwdriver. • Locate the slot in the base cover, and insert the flat-tip screwdriver into the slot. Push in and hold the retaining tab. • While holding the retaining tab, push up on the sunvisor and rotate it. NOTE: If the retaining tab did not stay pushed in, return the sunvisor to its original position and repeat this step. 4. Remove the left sunvisor holder: • Wrap tape around the tip of flat-tip screwdriver. • Release three retaining tabs on the left sunvisor holder. 5. Remove the driver’s A-pillar trim. • Pull back the door opening seal from the driver’s A-pillar trim. • Pull out on the driver’s A-pillar trim to release three clips. • To prevent clips from falling into the body panel area, carefully insert a shop towel between the driver’s A-pillar and the driver’s A-pillar trim. • Slide the driver’s A-pillar trim upward, and remove the driver’s A-pillar trim. • Remove the shop towel and any clips. 6. Remove the remaining upper clip from the driver’s A-pillar.