Home Auto Repair 2010 Chevrolet Montana Sliding Door Adjustment

2010 Chevrolet Montana Sliding Door Adjustment

73

Download 2010 Chevrolet Montana Sliding Door Adjustment [Manual or Power} – IN AND OUTADJUSTMENTS lfequipped with a power sliding door, disable the PSD system by removing the PSD 15A fuse from the instrument panel {llPlfuse block. IMPORTANT: Ely removing the power sliding door (PSD) 15A fuse, the low current logic power for both the LH and RH power sliding door modules {PSDlvljlwill be interrupted and both PSDs will be inoperative. Remove the sliding door´Čünish molding. IMPORTANT: When adjusting eitherthe manual or the power sliding door, loosen only one bolt at a time on the sliding door lower roller bracket and the sliding door center roller bracket. Failure to loosen one bolt at a time may result in a complete loss of sliding door alignment. Remove the sliding door trim panel. Loosen the 2 vertical sliding door lower roller bracket bolts. Loosen the sliding door lower bracket bolts. Adjust the front edge ofthe sliding door in or out as needed. Tighten the loosened sliding door lower bracket bolts. NOTE: Referto Fastener Notice in Service Precautions. Tighten the vertical bolts to 25 N.m [18 lb ft]. Loosen the sliding door upper roller bracket {1} bolts. Adjust the upperdoor in or out. Tighten the bolts, as sequenced, to 25 N.m [18 lb ft]. Loosen the sliding door center roller bracket (1) bolts. Adjust the rear edge ofthe sliding door in or out as needed.